What Will Cause You To Fail Inspection?

Will bad struts fail inspection?

Penna inspection requires a car be rejected from passing during the inspection of the suspension system “when checking the shock absorbers the vehicle continues free rocking motion greater than three cycles after release” or “if upon internal inspection, the shock absorbers have severe leakage – not slight dampness.”.

What will fail a NC car inspection?

Tires. Your tires are your most critical safety component and are also one of the things most likely to cause you to fail a safety inspection. All tires must be in good condition and have at least 2/32 inch of tread depth remaining. Any tires under this specification must be replaced before your vehicle can pass.

Will a car pass inspection with a headlight out?

If you have a cracked headlight or taillight, be warned that it won’t pass inspection. Do not attempt to tape the light, even with red adhesive tape, as most states specifically prohibit this.

How much tire tread should you have?

Good tire tread depth will be 6/32 or deeper. If the depth is 4/32, you should start thinking of replacing your tires and getting new ones. 2/32 or less means that you should change your tires ASAP. The amount of tire tread can affect your stopping distance, making a drive in wet or snowy conditions more dangerous.

Will needing an oil change affect inspection?

Emissions tests have very little to nothing to do with oil changes and nothing to do with safety inspections. BUT if you don’t maintain your car as for example by failing to change the oil, you may also be failing to maintain it well enough to pass the emissions tests.

What can keep your car from passing inspection?

Top 10 Reasons Your Car Won’t Pass InspectionDefective “Check Engine” Light. This one comes first because it’s so simple you might never have considered it. … Clogged Air Filters. … Defects in the EVAP. … Worn Out Windshield Wipers. … Dirty Engine Oil. … Leaking Gas Caps. … Defective Catalytic Converters. … Broken Spark Plugs.More items…•

When you get your car inspected what do they look for?

Areas for inspection include: Working electrics such as headlights, blinkers, interior lights and dash lights. Engine/suspension/exhaust and driveline condition. Seatbelt condition. Engine and driveline fluid leaks.

Can you fail an inspection because of tires?

If there is more wear on either the inside or outside, chances are that your car is out of alignment, if the tires treads are the wear bars in three locations, your tires will most likely fail state inspection.

What are the three things you should be checking for when inspecting your tires?

The three big things you need to examine are: the tread depth, different kinds of wear and tear, and your tire pressure….Here’s a little more detail about why and how you should make sure your tires are in tip-top shape:Tread Depth. Tread depth is essential to a well-performing tire. … Wear and Tear. … Pressure.

Can rotors fail inspection?

RUSTED/PITTED BRAKE ROTORS The presence of rust or pitting on brake rotors, by itself, does not constitute a failure for the purpose of inspection. Inspectors should determine if rust is a temporary condition (surface rust) which sometimes results from the vehicle being parked for a period of time.

Do they check headlights for inspection?

A safety inspection checks to make sure that all of your car’s lights are in good working order. Beyond headlights, this also includes your high beams, emergency flashers (front and back), turn signals (front and back), side lights, brake lights and backup lights.